Section: Maintenance Commands (8)
Updated: September 2005
Return to Main Contents
i2cset - set I2C registers
i2cset is a small helper program to set registers visible through the I2C
Display the version and exit.
Disable interactive mode. By default, i2cset will wait for a confirmation
from the user before messing with the I2C bus. When this flag is used, it
will perform the operation directly. This is mainly meant to be used in
There are four required options to i2cset. i2cbus indicates the number
of the I2C bus to be scanned. This number should correspond to one of
the busses listed by i2cdetect -l. chip-address specifies the
address of the chip on that bus, and is an integer between 0x00 and 0x7F.
data-address specifies the address on that chip to write to, and is an
integer between 0x00 and 0xFF. value is the value to write to that
location on the chip.
The mode parameter, if specified, is one of the letters b or
w, corresponding to a write size of a single byte or a 16-bit word,
respectively. A p can also be appended to the mode parameter to
enable PEC. If the mode parameter is omitted, i2cset defaults to byte
mode without PEC. The value provided must be within range for the
specified data type (0x00-0xFF for bytes, 0x0000-0xFFFF for words).
The mask parameter, if specified, describes which bits of value
will be actually written to data-address. Bits set to 1 in the mask
are taken from value, while bits set to 0 will be read from
data-address and thus preserved by the operation.
i2cset can be extremely dangerous if used improperly. It can confuse your
I2C bus, cause data loss, or have more serious side effects. Writing to
a serial EEPROM on a memory DIMM (chip addresses between 0x50 and 0x57) may
DESTROY your memory, leaving your system unbootable! Be extremely careful
using this program.
Frodo Looijaard, Mark D. Studebaker, and the lm_sensors group
This manual page was originally written by David Z Maze <email@example.com> for
the Debian GNU/Linux system. It was then reviewed by the lm_sensors team and
is now part of the lm_sensors source distribution.
- CONFORMING TO
- SEE ALSO
linux.jgfs.net manual pages