Section: Maintenance Commands (8)
Updated: September 2005
Return to Main Contents
i2cget - read from I2C/SMBus chip registers
i2cget is a small helper program to read registers visible through the I2C
bus (or SMBus).
Display the version and exit.
Disable interactive mode. By default, i2cget will wait for a confirmation
from the user before messing with the I2C bus. When this flag is used, it
will perform the operation directly. This is mainly meant to be used in
scripts. Use with caution.
There are two required options to i2cget. i2cbus indicates the number
of the I2C bus to be scanned. This number should correspond to one of
the busses listed by i2cdetect -l. chip-address specifies the
address of the chip on that bus, and is an integer between 0x03 and 0x77.
data-address specifies the address on that chip to read from, and is
an integer between 0x00 and 0xFF. If omitted, the currently active register
will be read (if that makes sense for the considered chip).
The mode parameter, if specified, is one of the letters b,
w or c, corresponding to a read byte data, a read word data or a
write byte/read byte transaction, respectively. A p can also be appended
to the mode parameter to enable PEC. If the mode parameter is omitted,
i2cget defaults to a read byte data transaction, unless data-address is
also omitted, in which case the default (and only valid) transaction is a
single read byte.
i2cget can be extremely dangerous if used improperly. I2C and SMBus are designed
in such a way that an SMBus read transaction can be seen as a write transaction by
certain chips. This is particularly true if setting mode to cp (write byte/read
byte with PEC). Be extremely careful using this program.
This manual page was strongly inspired from those written by David Z Maze
- CONFORMING TO
- SEE ALSO
linux.jgfs.net manual pages